Back Panel for Solid State and Tube Models.

NORMAL AND +6Db INPUTS: +6Db provides the most volume with a heavier amplified sound. Use Normal Input with strong pickups to avoid overdriving the preamp. (+6Db = Input 1 and Normal = Input 2 on older models). Located on top front panel.

MASTER: Used to set the output gain of the preamp. On newer models the convenient on/off switch on this knob requires the first part of the control. So, don't be afraid to turn it from 3 to 7. Located on top front panel.

BUFF: This solid state preamp control provides beautiful overtones found in tube amplifiers. Start with Buff on 4 to 6. Next, use your ear to adjust the Treble then the Expand switch. Located on top front panel. (Models made before 2004 had the Scruff control which warmed the sound while cutting some of the highs and was not recommended for Pedal Steel Guitar.)

REVERB: This control mixes in the amount of reverb effect desired. Digital reverb now standard on Evans Amplifiers. Located on top front panel.

REVERB SELECTION: A rear panel switch selects Reverb alone, Reverb plus Flange, or Reverb plus Chorus. (Currently unavailable with Solid State AH200.)

DWELL: This rear panel control sets room size or reverb interval. The Dwell control has a convenient center detent value sufficient for most musicians. (Currently unavailable with Solid State AH200.)

BASS: Sets the amount of bass desired. The maximum Bass should be dialed in by playing the lowest open string and turning up the knob from 0 until it gets boomy and then backing off by a number. Turn down the Bass to 5 or less when using +6Db Input with Master greater than 6 or Normal Input with Master greater than 7. If the Bass knob is turned up while playing at loud volume, the low end will be overcompensated and muddy because bass frequencies are easier to reproduce at loud volumes. Located on top front panel.

DEPTH: This control enhances the low and low midrange. Turn clockwise 50 – 75% for the most musical tone. Roll back at louder volumes to prevent distortion. Body knob must be set > 1 for best Depth operation. Located on top front panel.

BODY: Used to set the amount of midrange and darkness, this is a multi-function control that increases low mid-range tones while rolling off high frequencies. Located on top front panel.

EXPAND: This switch boosts the highs, and some lows. Up is on, down is off. Located on top front panel.

TREBLE: Selects the amount of treble desired. On new models the Treble should be dialed in by playing the highest open string and turning up the knob from 0 until it gets thin and then backing off by a number. The most solid Treble sound is 0-2. Located on top front panel.

VOLUME: Sets the input level to the pre-amp. Lower settings (3-5) reflect the instrument's voice. Higher s